WIFI‐Repeater (Pending to be implemented)
5.9
NCP models including the WIFI interface can act as a WIFI‐Repeater in order to reach
longer distances.
To reach such distances you need two NMEA Connect Plus devices with WIFI. A WIFI
peer to peer connection is created between them. The first NCP (transmitter) will
take the wind data from the selected input interface (depending on the model) and
will transmit it via WIFI to the second NCP (receiver). This one will export the
received
data into the selected output interfaces (NMEA 0183, NMEA 2000 or BLE).
6
Installation
Before you start the installation make sure all power sources are off!
To connect a cable to the NCP internal interface follow the steps below:
1.
Remove the screws to open the NMEA Connect Plus gateway. The connectors are in the
position as the following image shows.
2.
Loosen the holder to introduce the cable inside
and pass the cable through the hole.
3.
Connect the wires in the correct position according to the information given in the
following sections. To put the wire into the connector, push with your finger or with a
tool.
USB
Connector
CAN
Connector
RS‐485 Connector
and Power
