1. Carefully remove the core and cable from their packaging. If there are any signs of damage, please contact Calrec
Customer Support and do not continue.
2. Confirm that the Pri / Sec switch on the rear of the core is set in the
Pri
position (switched to the left).
3. Connect the power cable to both PSU inlets on the rear of the core and power it on. The core will boot up with
the PRI LED lit and after approximately 30 seconds the
OK
LED will light solid green to indicate a good status.
The
Recover Led
should be lit Green or not lit,
Fan Fail
&
PSU Fail
LEDs should not be lit.
4. Configure the Ethernet adapter in your PC with IP address
172.16.255.99
and subnet mask
255.255.255.0
Note:
Please refer to your PC’s operating instructions, if you are unsure how to configure its ethernet adapter.
5. Connect the ethernet adapter to the
Setup
port on the front of your Type R core.
POWER CONNECTION TO CORE AND PC CONNECTION TO CORE SETUP PORT
1. POWER UP THE CORE AND CONNECT A PC
