Caloric CVU306C-SS, Инструкция по использованию и установке

Страница: 9 / 48

IMPORTANT: Observe all governing ordinances and local codes.
(Please consult with a qualified electrician for any electrical wiring)
It is the customer’s responsibility:
•
To contact a qualified electrical installer.
•
To assure that the electrical installation is adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 — latest edition*, or CSA Standards C22. 1-94, Canadian
Electrical Code, Part 1 and C22. 2 No. 0-M91 - latest edition**
It is your responsibility to
be aware of and adhere to all building, fire, electrical, safety, and any other applicable
codes with regards to the installation and use of this range hood.
•
Provide a circuit protected power service; preferably a Ground Fault Circuit Interrupter
("G.F.C.I."): 120-volt, 60 Hz, AC, with at least 5-amps of available service.
•
Enlist a qualified electrician to ensure the range hood and electrical lines are adequately
grounded and properly protected.
NEVER
electrically ground to a gas pipe.
•
IMPORTANT: Save this Installation Guide for future reference and/or electrical inspector
use.
•
The range hood should be connected with a circuit breaker protected power service.
•
Wire sizes (copper wire only) and connections must conform with the rating of the
appliance as specified on the model/serial rating label.
Wire sizes must conform to
the requirements of the National Electrical Code and any and all local codes and
ordinances. A U.L. - or C.S.A. - listed conduit connector must be provided at
each end of the power supply cable (at the range hood and at the junction box).
Pg 8
Electrical Requirements
Advanced Preparation
Advanced Preparations:
1. Familiarize yourself with the controls of the range hood
by reading through
Range Hood Operations
, Page 1 5 .
2. Place the range hood on a flat, stable surface. Connect
the range hood to a designated standard outlet (please
refer the product label for the suitable voltage of this
unit) and turn on the range hood. Verify all operations
of the range by referring to
Range Hood Operations
,
on Page 15.
Place all supplied parts and required hardware on a flat, stable surface and verify
the presence of all supplied parts listed on Page 4.
Carefully
remove the white plastic protective coat from t he range hood.
Excessive Weight
Require three or more persons to
move and install this range hood.
Spinal or other bodily injuries
could occur if it is not followed.
3.
4.