IMPORTANT SAFETY PRECAUTIONS
READ AND SAVE THESE
INSTRUCTIONS CAUTION
For residential use only. Do not use to exhaust hazardous or explosive materials and/or vapors.
CAUTION
Range hood may have very sharp edges; please wear protective gloves when installing, cleaning
or servicing the unit.
This appliance must be installed by a qualified technician. The manufacturer declines all
responsibility in case of failure to adhere to safety standards. Install this hood in accordance with
all the specified requirements
.
WARNING
To reduce the risk of fire, electric shock or injury to persons, observe the following:
•
Use this unit only in the manner intended by the manufacturer. If you have any questions,
contact the manufacturer.
•
Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. If the service
disconnecting means cannot be locked, securely fasten a noticeable warning device, such as a
tag, to the service panel.
•
Installation work and electrical wiring must be done by a qualified person in accordance with
all applicable codes & standards, including Fire-rated construction.
•
Sufficient air is needed for proper combustion and exhausting of gases through the chimney
(chimney) of fuel burning equipment to prevent back-drafting.
•
Follow the heating equipment
manufacturer’s
guideline and safety standards such as those
published by the
National Fire Protection Association
(NFPA) and the local code authorities.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
•
Ducted fans must always be vented to the outdoors.
•
Do not make alterations to the original wiring.
•
Do not attempt to repair or replace any part of your hood unless it is specifically
recommended in this manual.
•
All other servicing issue should be referred to a qualified technician
.
CAUTION:
To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into
spaces within such as walls, ceilings, attics, crawl spaces, or garages.
Automatically operated device - to reduce risk of injury disconnect from power supply before servicing.