INSTALLATION
Measure the distance between the cooking
element and the bottom of the range hood.
A distance of 28” to 30” is recommended*.
*
Due to different ceiling height configurations,
the recommended height may not be
applicable
.
Step 1
: You have
two options
for installing this range hood (see INSTALLATION DIAGRAMS on page 22).
Determine the venting method and proceed as follows:
1.
Using references in the
Height & Clearance
diagram, determine and clearly mark the
centerline on the bottom of the cabinet.
2.
Draw electrical wires through cabinet access opening on top or back of the range hood,
center the hood beneath the cabinet and flush with the front of the cabinet.
3.
From the inside of the hood, place hood mounting screws in the exact center of each
knockout holes and secure to the cabinet bottom. Tighten all screws until secure. Be
careful when using electrical screwdriver in order not to damage the range hood. If
venting is to be done vertically, connect and secure the
6’’
round metal duct (refer to figure
1).
CAUTION: Make certain the range hood is secure before releasing!
Step
2
:
For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For a
more secure installation, use as many mounting holes as needed to secure the hood from the inside.
In the case of vertical evacuation use a 6” round metal pipe (as in figure 1) to connect the exhaust on the
hood to the ductwork. Use duct tape to make all joints secure and airtight.
Step 3:
Turn power ON in control panel. Check all lights and fan operations.
Figure
1