Caloric CSG7601, Руководство пользователя

Страница: 13 / 64

13
Seal Openings
Openings in wall behind the range or on floor under range
must be sealed before sliding range into position.
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1.
Measure 3 1 /
2
inches from back wall on right and left
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3
1 /
2
inches from back wall and side of
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
or
3 1/2"
Anti-tip Bracket Installation
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
3
/
32
inch drill bit.
• If drilling into concrete, use a
3
/
16
inch masonry drill
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position.
7. Remove range storage drawer and confirm anti-tip
bracket is engaged with range leveling leg after range
is in place.
Place Range
Plug in range. Slide range into place. Carefully level range
using legs provided. Range must be level to cook and
bake uniformly.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended out ¼ inch to engage
anti-tip bracket.
Removal and Reinstallation of Range
1. Unplug range cord.
2. Turn off gas valve and disconnect gas supply.
3. Remove range and place aside.
4. Remove anti-tip bracket and reinstall anti-tip bracket
into new location using instructions provided with
bracket.
5. To reinstall range, follow instructions in Installation
section of this manual.
• Do not reuse a flexible connector after moving
appliance.
Place Grates and Burner Caps
Place burner cap on burner base and grate on rangetop.
A
B
C
A—Burner grate
B—Burner cap
C—Burner base
Place Grates and Burner Caps
Pegs in the burner base fit into recess in underside of
burner cap. To make sure cap is properly aligned and
leveled, move burner cap around on burner base. Burner
cap must be correctly seated on burner base for proper
operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap is
placed on burner base.
Turn on burners to check for proper operation. See
Operating Surface Burners section for burner operating
instructions.
Anti-Tip and Burner Installation