10
Converting Surface Burners for Use with LP/Propane
1.
Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.
2.
Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3.
Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See
Pivot Point in figure.
• Gas valve and orifice hood are visible after burner
control panel is removed.
A
B
C
D
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
Burner Control Panel
4.
While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end
wrench.
• Do not over tighten orifice hoods. If orifice hoods are
over tightened, gas supply can be cutoff or orifice
hoods can strip.
5.
Open air shutter fully.
A
B
Open Fully
A—Orifice Hood
B—Air Shutter
Converting Surface Burners for Use with LP\Propane
and air shutter.
3.
Turn orifice hood clockwise until snug.
• Do not overtighten orifice hoods. Orifice hoods can
strip. Support orifice fitting wiht wrench to avoid
damage to gas supply tubing.
4.
Replace cover plate and storage drawer.
A
B
C
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
Converting Oven Burner
6.
Reassemble burner control panel after adjusting air
shutter.
• See
Adjusting Surface Burner Flame section.
Converting Oven Burner for Use with LP/Propane
1.
Remove storage drawer.
• See
Removing Storage Drawer section.
2.
Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
Converting for Use With LP/Propane
(cont.)
Содержание CSG7601
Страница 62: ...62...