Caloric CPR SERIES, Инструкция по использованию и уходу, Страница: 22 / 56

Installation Introduction
22
Use & Care Manual
CONNECT RANGE TO GAS SUPPLY:
1. I
NSTALL MALE
1
/
2
”
FLARE UNION ADAPTER TO
1
/
2
” NPT
INTERNAL THREAD ELBOW AT INLET
OF REGULATOR
. O
N MODELS EQUIPPED WITH STANDARD TWIN BURNERS
,
INSTALL THE MALE
PIPE THREAD END OF THE
1
/
2
”
FLARE UNION ADAPTER TO THE
1
/
2
” NPT
INTERNAL THREAD
AT INLET OF PRESSURE REGULATOR
. U
SE A WRENCH ON THE REGULATOR FITTING TO AVOID
DAMAGE
.
2. I
NSTALL MALE
1
/
2
”
OR
3
/
4
”
FLARE UNION ADAPTER TO THE
NPT
INTERNAL THREAD OF THE
MANUAL SHUT
-
OFF VALVE
,
TAKING CARE TO SECURE THE SHUT
-
OFF VALVE TO KEEP IT FROM
TURNING
.
3. T
HE GAS SUPPLY PRESSURE FOR CHECKING THE REGULATOR SETTING IS
6”
W
.
C
. (N
ATURE
G
AS
)
AND
11”
W
.
C
. (LP
GAS
)
CONNECT FLEXIBLE GAS LINE CONNECTOR TO THE REGULATOR
ON THE RANGE
. P
OSITION RANGE TO PERMIT CONNECTION AT THE SHUT
-
OFF VALVE
.
4. W
HEN ALL CONNECTIONS HAVE BEEN MADE
,
MAKE SURE ALL RANGE CONTROLS ARE IN THE
POSITION AND TURN ON MAIN GAS SUPPLY VALVE
.
5. L
EAK TESTING OF THE APPLIANCE SHALL BE CONDUCTED ACCORDING TO THE
MANUFACTURER
’
S INSTRUCTIONS
. U
SE SOME SOAP WATER
(50%
WATER AND
50%
SOAP
)
OR A LEAK DETECTOR AT ALL JOINTS AND CONNECTIONS TO CHECK FOR LEAKS IN THE
SYSTEM
. D
O NOT USE A FLAME TO CHECK FOR GAS LEAKS
.
6. T
HE APPLIANCE MUST BE ISOLATED FROM THE BUILDING
’
S GAS SUPPLY PIPING SYSTEM BY
CLOSING ITS INDIVIDUAL MANUAL SHUT
-
OFF VALVE DURING ANY PRESSURE TESTING OF THE
GAS SUPPLY PIPING SYSTEM AT TEST PRESSURE EQUAL TO OR LESS THAN
1
/
2
PSIG
(3.5
K
P
A
).
PLEASE VISIT US AT: WWW.CALORICAPPLIANCES.CA