Paragon-X Getting Started Guide
Page 10 of 28
Connecting Power and Your Computer to Paragon-X
1.
Connect your computer to the PC Controller port on the front panel of Paragon-X.
2.
Connect the AC adaptor to the rear panel DC power input connector.
3.
Connect the power cord to the AC adaptor and plug into an AC outlet.
4.
Use Paragon-X’s rear panel power switch, marked
I
/0, to switch on Paragon-X.
5.
The blue display on the front panel will turn on. Paragon-X is initialised and ready to use after
approximately 90 seconds. Note that on first power up, the IP address shown on the display is
factory-preset and can be changed to meet your network requirement. To do this, install the
Paragon-X application software (as described in ‘Installing the Application Software’), then click on
Instrument(s) then Change IP Settings.
