Become an aware user:
If you notice that the fireplace is not working or you can smell gas in the room, turn it
off immediately, cut off the fuel supply to the device, close the gas valve, disconnect the
electric circuit, ventilate the room and contact the service center.
If the pilot flame extinguishes during operation, wait at least 10 minutes before re-
starting.
Supervise children and other people who require special attention when using the
heater.
Do not touch a burning fireplace as it heats up to high temperatures.
Do not run the fireplace without installed windows. If they are damaged in any way,
they must be replaced immediately.
Only decorative elements supplied by the manufacturer may be installed in the de-
vice in accordance with the full Instructions for Use.
Ceramic logs used in the device are elements of a gas burner. Modifications to their
arrangement are not allowed.
There must not be curtains, wooden furniture, MDF board furniture, upholstered fur-
niture, plastic items, laundry dryers and other flammable materials directly above the
device and at a distance of at least 2 m from the glass.
If the heater will not be used for an extended period of time, shut off the gas supply.
Remember to commission periodic inspections of both the installed equipment and
the associated air / flue gas system.
1
2
3
4
5
6
7
8
9
10
FIRING UP THE DEVICE
Press and hold
SET
until you hear a short beep. Release the button. The heater will start
the firing-up procedure and the display will show
“PILOT”
. After firing up, the display will
show the
“ON”
symbol and the device will automatically set the maximum flame height
If the device does not start, the procedure will be repeated automatically two more times.
If the heater is not activated, the message
“E00”
will appear on the display. Disconnect the
gas supply to the device and contact the service center.
MINIMUM AND MAXIMUM FLAME HEIGHT / STAND BY MODE
With the heater working.
Increasing the flame height.
Press
.
Reducing the height of the flame.
Press
.
The heater is controlled by TESC automatics and has seven levels of regulation of the flame
height of the main burner.
CHILD PROOF MODE ACTIVATION
The TESC remote control (type FB 868D) has an automatic protection. To unlock the device,
place the remote control in your hand in such a way as to activate the sensors on both sides
of it at the same time. The unlocking of the remote control is signaled by the green diode
above the
SET
button. The remote control must be unlocked to be able to control the heater.
TURNING OFF THE DEVICE
With the heater operating, press . After the putting out procedure is completed, the
message
“OFF”
will appear on the display. If the device is warmed up, wait 5 minutes
before trying to fire again.
CHANGING THE BATTERY IN THE REMOTE CONTROL
Control with the use of TESC automation
■
Remote control - 2 x 1.5V AA batteries
■
Control module - 3 x 1.5V AA batteries
On the TESC remote control, the symbols
“RC”
and
“FC”
are displayed
alternately by the battery indicator.
“RC”
shows the battery level of the
remote control, and
“FC”
shows the battery level of the control unit. Ran-
dom error codes may appear on the display if the battery in the control
module is completely discharged.
Used batteries in the receiver and the remote control should be placed
in special containers for this type of waste.
The full and up-to-date content of the User Manual
is available at
www.mycalma.eu
The CALMA line of prestigious gas fireplaces was created
and produced by the brand
