Fig. 1 Front and Back Views of 8 Line Model
2
Standard RS232
1200 or 9600 Baud.
(Default is 9600 Baud).
8 Bit, 1 Stop, No Parity.
Top jack connects to
bottom jack of addional unit.
Standard RS232
1200 or 9600 Baud.
(Default is 9600 Baud).
8 Bit, 1 Stop, No Parity.
Top jack connects to
bottom jack of addional unit.
To Next Unit
To Computer
9600 Baud,N,8,1
Lines 5 & 6
OUT
IN
Lines 7 & 8
OUT
IN
Lines 1 & 2
OUT
IN
Lines 3 & 4
OUT
IN
9VDC
Power
Jack
(9 VDC
Center
Negative)
Power
Jack
(9 VDC
Center
Negative)
Complies with FCC Part 68. FCC
Reg. No. 2EWUSA-73088-ND-N
REN 1.6B, Jack (USOC) RJ14
Model: Whozz Calling?
DIP Switch Controls
#1-3 Set unit line numbers when 2 or more units
are connected together
#4 Caller ID Signal Type Transmitted by TelCo
(Off -FSK, On -DTMF)
#5 Baud rate (Off -9600, On -1200)
#7 Output Format (Off -CallerID.com, On-TCI)
#8 Unit model (Off -8 line, On -4 line)
#9 Not Connected
DIP Switch Controls
#1-3 Set unit line numbers when 2 or more units
are connected together
#4 Caller ID Signal Type Transmitted by TelCo
(Off -FSK, On -DTMF)
#5 Baud rate (Off -9600, On -1200)
#7 Output Format (Off -CallerID.com, On-TCI)
#8 Unit model (Off -8 line, On -4 line)
#9 Not Connected
3
2
4
5
1
6
7
8
Device #
CID Signal
Baud Rate
Format
4/8 Line
N/C
[1-3]
[4]
[5]
[7]
[8]
[9]
Caller
.com
ID
ID
Standard RS232
1200 or 9600 Baud.
(Default is 9600 Baud).
8 Bit, 1 Stop, No Parity.
Top jack connects to
bottom jack of addional unit.
Standard RS232
1200 or 9600 Baud.
(Default is 9600 Baud).
8 Bit, 1 Stop, No Parity.
Top jack connects to
bottom jack of addional unit.
To Next Unit
To Computer
9600 Baud,N,8,1
9VDC
2 conductor jacks connect
to each phone line using
1 pair of wires on cord.
2 conductor jacks connect
to each phone line using
1 pair of wires on cord.
Power
Jack
(9 VDC
Center
Negative)
Power
Jack
(9 VDC
Center
Negative)
Complies with FCC Part 68. FCC
Reg. No. 2EWUSA-73088-ND-N
REN 0.5A, Jack (USOC) RJ11
L1
L3
L5
L7
L2
L4
L6
L8
CALLING?
WHOZZ
POS Caller ID
8
During power-up, LEDs will flash and
then remain on. When the line rings,
the LEDs will follow the ring cycle.
During power-up, LEDs will flash and
then remain on. When the line rings,
the LEDs will follow the ring cycle.
