*
! "#$%# & $'(
) ! "#$"# & $'(
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
31
Only use suitable and undamaged tools.
Only connect the device according to the supplied connection diagram!
Setting up
Remove the items packed separately (accessories) from the main carton, and
check them for completeness.
1 connecting cable 230 V, 1 m.
1 plug connector, 12-pole
4 fastening screws
1 plug connector, 15-pole
4 washers
18 contact pins
1 operating instructions.
Option
(not included)
Quick connector for battery "Quick power", part no. H10 432 0110 00
Temperature sensor for battery II part no. H10 012 0003 00
The device should be set up in a location not exposed to humidity and damp.
The setting up location must be clean, dry and well-ventilated. During
operation, the housing may heat up to approx. 75° C. Therefore maintain a
minimum clear distance of 100 mm and make sure that the ventilation slots are
not covered.
Length: 502 mm / Width: 373 mm / Height: 210 mm
The space provided for the device must not be smaller than the dimensions
specified here, since a minimum clear distance of 100 mm must be provided
all the way around it. The separate box for the device must be provided with
ventilation holes at the top and sides, with a total area of 10,000 mm².
The device should be placed as close as possible to the battery, but always in a
separate box. The box for the battery must have a ventilation hole facing
towards the outside.
Attach the device securely with the four fastening screws supplied. The legs of
the device can be turned 90°. To do so, the bolts at the legs must be loosened.
Then the legs can be turned and re-tightened.
Important
Make sure that the ventilation slots remain unobstructed! The minimum clear
distance must be 100 mm all around! Insufficient ventilation can cause
overheating of the device! The device is designed for operation in ambient
temperatures of up to 35° C. If the temperature inside the device rises due to a
