• Remove your La Paz from its protective packaging
and place on LEVEL SURFACE in the desired location.
To obtain proper water flow it is critical that the La
Paz unit be placed on a LEVEL SURFACE.
• The black trim ring (830) will be in place at the top
of the La Paz.
• The Stainless Steel burner will be held in place by
the black trim ring (830). If it has shifted in trans-
portation be sure that the burner is placed back into
the trim ring.
•
Check to be sure that the burner is free of any
debris and water before using.
• Check all fittings to be sure that they are connected
and tightened appropriately.
• Check list:
• Connector hose is attached to the top side of the
integrated valve located in the side of your unit and
to the LP orifice located at the termination of your
burner.
• For LP connections the end of the hose with regula-
tor is connected to the LP gas supply (tank) and the
opposite end of hose is attached to the bottom of
the integrated valve.
• For Natural Gas installations:
• Replace the orifice that is installed in your burner
with the Natural Gas Orifice that is supplied in your
instruction envelope.
• Note: If you have a Natural Gas set up, you will not
use the hose with the regulator.
• Connect the natural gas supply to the open end of
your integrated valve. This can be accomplished
with a flex line which you will need to purchase.
• Check all connections for a gas leak by using a
soapy water spray. Bubbles will appear if a leak is
present. If bubbles appear, tighten the connection
and test
the area again. Continue this process until you are
comfortable that there are no leaks present in your
gas supply system.
• Place your LP tank on the metal platform located
above the water reservoir at the bottom of the La
Paz and attach the LP hose with regulator.
• Your La Paz firepit is match-lite and requires the use
of a long handle lighter.
• Load your burner with the supplied media (glass or
gas logs) before lighting.
• Light the long handle lighter and hold over the firepit.
• Turn the gas on slowly to allow for a small fire upon
ignition. After ignition remove the long handle
lighter and adjust the flame to the desired height.
•
Excessive gas should not be used for lighting!!!!!!
Once you have completed the gas hook up portion
of the assembly, you are ready to go forward:
• Check to be sure that the water hose is connected
to both the pump and the outlet to the face of the
La Paz.
• Place your pump into the water reservoir which for
the La Paz is the bottom of the base unit.
• There is a recess at the bottom of the door opening
to allow the electric cord to be laid into it and the
door to be located in a secure fit.
• Fill the base with water approximately 4 – 5 inches of
water. Enough to cover the pump, but not so much
for it to pour out of the front return crevice.
• Before plugging the pump into the electric outlet, be
sure to wet down the entire face of the La Paz to
minimize the opportunity for water
to spill onto the floor surface.
• The water pump supplied with
your La Jolla allows you to adjust
the water flow, if necessary.
• Place the door in place and enjoy
your La Paz.
La Paz
Waterfall Firepit Series
Water Feature Fire Pit Set Up
w w w . c a l i f o r n i a o u t d o o r c o n c e p t s . c o m
4
