CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
Overview
market
LITE
™
ML
2000-CM
2 of 11
WARNING
When using marketLITE for any application, basic safety precautions
should always be followed to reduce the risk of fire, electric shock, and
personal injury. marketLITE must be installed in accordance with the
NEC or CEC as applicable.
• Do not power or light marketLITE when tightly coiled. Maintain at least
one half inch spacing between parts when lit.
• Do not cover marketLITE, the covering may cause it to overheat, melt,
or ignite
• Do not route marketLITE through walls, doors, windows, or building
structures
• Do not roll out marketLITE on rough surfaces or over sharp corners.
• Do not use marketLITE if damaged, such as, broken outer jacket, loose
connections, or frayed wire insulation. Inspect periodically
• Do not secure marketLITE with staples, nails, or like means that might
damage the insulation. Secure by using mounting aircraft hook
• Do not submerge marketLITE in liquid or install near standing water or
other liquids
• Do not install marketLITE where it is subject to continuous flexing
• Do not mount marketLITE inside cabinets, tanks, or enclosures of any
kind without proper ventilation
• Do not run marketLITE at an operation temperature below -40°C (-40°F)
or above 55°C (131°F)
• Ground Fault Circuit Interruptor (GFCI) protection is required on
circuits or outlets when marketLITE is used for outdoor applications
• Surge protector must be set up for electrical power system to avoid
damaging marketLITE lighting system
FEATURES
APPLICATIONS
Indoor and Outdoor Lightstring
VOLTAGE
120V
LAMP
LED Lamp Included
DIMMING
Forward Phase
WATTS
1W or 3W
LENGTH
Built to Order
FINISH
Black
FEED
Standard 6’ Leads
STRAIN RELIEF
Aircraft Cable Included
LISTING
Dry or Wet Location
OPTIONS
Mesh, Cages, Canopies
LED LAMP LIFE
50,000 hrs.
MAXIMUM RUN
250 Feet
SERIES
WEIGHT
ML2000-CM-12”O/C-LED-XX-DM-WET
0.79 lbs per foot
ML2000-CM-18”O/C-LED-XX-DM-WET
0.56 lbs per foot
ML2000-CM-24”O/C-LED-XX-DM-WET
0.45 lbs per foot
ML2000-CM-36”O/C-LED-XX-DM-WET
0.34 lbs per foot
ML2000-CM-48”O/C-LED-XX-DM-WET
0.29 lbs per foot
ML2000-CM-60”O/C-LED-XX-DM-WET
0.25 lbs per foot
WEIGHT PER FOOT
Symmetric Forward Phase-Control
DIMMING PROTOCOL (LED FORWARD PHASE DIMMING)
Technical Requirements For Control Equipment
(Forward Phase Dimming)
•
Electrical Characteristics - Inductive
•
Special Requirements - Symmetric cycles
