CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
market
LITE
™
ML
2000-CM
7 of 11
Step by Step
1.
Install aircraft cable.
NOTE:
See previous page for cable mounting details.
2.
Hook socket onto aircraft cable.
6.
Fully insert wires into end cap.
TIP:
Allow silicone to seep out of end cap for a proper seal.
Check the silicone seal for holes or gaps.
NOTE:
Silicone must be non-conductive and weatherproof
3.
Cut excess wire at end of run.
TIP:
Use sharp wire cutters to create a clean cut and avoid fraying.
7.
Install bulbs into sockets, then install cages into canopies.
NOTE:
Do not over-tighten bulbs.
Over-tightening compromises weather seal, damaging internal components.
NOTE:
A small amount of the screw threads will show between socket and bulb.
Do not attempt to screw bulb beyond this point.
Mounting eye (not included)
Cable lock
Aircraft cable
Sharp cutters
Good
Insufficient jacket covering.
Wires will touch inside end
cap and cause a short circuit.
4.
Check that wires or strain relief cable are not touching.
TIP:
Contact between any of the wires will result in a short.
5.
Apply silicone to inside of end cap.
Apply silicone
(not included)
Silicone seeps
out around edge
Small gap
8.
Cut lead wire to desired length.
Use sharp cutters to ensure clean cut
