CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
lip
LED
™
LLED
8200-ST
9 of 11
Troubleshooting
TROUBLESHOOT
• Do not reset breaker multiple times.
• If the unit is overloaded the breaker will trip shutting off the
transformer and lights.
• If the breaker reset button has been held down by hand or any type
of pressure (example: duct tape), or if the breaker has been reset
multiple times without trouble shooting, the unit will:
- Burn the transformer bobbin
- Burn the thermal or magnetic breaker
- Burn the primary or secondary wires due to high amperage caused
by overload and/ or short circuit in line which will not allow the
breaker to reset
- Damage the lighting
1.
Turn off power before beginning. Check for any damage to the circuit in
the LED board. If there is excessive damage and circuit is broken, the
board must be replaced.
2.
Check for metal particles or other foreign objects causing the short.
3.
Check for broken or improperly cut boards.
4.
Ensure the board are properly aligned and not overlapping
5.
Ensure loose wires are not making contact with aluminum extrusion.
6.
Check for water inside end cap and power connector. If water is
present, remove water before connecting to power.
7.
Do not connect boost tap from transformer voltage. Ensure that voltage
does not exceed 24VDC.
Improper cut
Metal flakes
Foreign object
Damaged board
Overlapping boards
Loose wires touching extrusion
8.
Conduct continuity test.
9.
Set voltmeter to DC voltage, then test power source before connecting.
If a conductive
path is formed
between positive
and negative wire,
the multimeter will
beep. You need to
trouble shoot to
find the short.
If there is no
conductive path, the
multimeter will not
beep.
Troubleshoot
Good
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
Confirm the correct
voltage, depending on
the light strip.
Power source
DCV
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
10.
Connect power source to power connector. If LEDs do not turn on,
flip polarity (+,-) or power source connection to power connector.
TRA
Power
Source
Power connector
LLED8200-ST
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
