Page 2
Page 9
mode), CLK ON/CLK OFF, CLK 12/24 mode. After selecting the desired mode,
press the VOL- or VOL+ button to select one setup item of the desired mode.
1) TA SEEK/TA ALARM:
TA SEEK mode: when newly tuned station does not receive TP information for
5 seconds, the radio retunes to next station which has not the same station
(PI) as the last station, but has the TP information.
When TP information gets lost at the current station for retune time which is
set by RETUNE SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio
start to retune to next same PI station. When same PI station does not catch
in 1 cyclic search, the radio retunes to next station with TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is
not activated. Only double beep sound(ALARM) is out-put.
When newly tuned station does not have TP information for 5 seconds, beeps
come out.
When TP information gets lost at the current station for retune time, the beep
sound is out-putted.
When newly tuned station has not RDS signal, PI SEEK is suppressed somewhat
.
2) PI SOUND/ PI MUTE:
PI SOUND mode: if a car cruises that critical area back and forth, an oscillation
phenome-non can be occurred, because the different PI code can be receive
from a same AF. when the different PI sound (DIP) is heard once in a while, the
different PI sound will be heard for less than 1 second.
PI MUTE mode: under above same situation, a mute sound will be heard for
less than1second.
3) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not caught for retune time , the radio start to retune
to next same PI station.
When same PI station does not catch 1 cyclic search, the radio goes to last
station and waits for 4-5 minutes until PI code is received.
RETUNE L mode: selected as 150 seconds.
RETUNE S mode: selected as 90 seconds.
4) MASK DPI/MASK ALL:
MASK DPI mode: masked only the AF which has different PI.
MASK ALL mode: masked the AF which has different PI and NO RDS signal
with high field strength.
5)BEEP ON/BEEP OFF
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
6) VOL LAST/VOL DEFA
VOL LAST: The radio switches on at the actual volume it had when it was last
switched off.
VOL DEFA: After pressing SEL button, AVOL will be displayed. Then you can
pre-select a constant switch-on volume by using the VOL knob.
7)CLK ON/OFF
CLK ON: Clock will always show on the display when power off.
CLK OFF: Clock will disappear on the display when power off.
CONNECTOR A
1.
2.
3.
4. 12V
5. Auto Antenna Output
6.
7. 12V (To Ignition Key)
8. GROUND
CONNECTOR B
1. Rear Right Speaker (+)
2. Rear Right Speaker (-)
3. Front Right Speaker (+)
4. Front Right Speaker (-)
5. Front Left Speaker (+)
6. Front Left Speaker (-)
7. Rear Left Speaker (+)
8. Rear Left Speaker (-)
ISO SOCKET SKETCH
F
U
S
E
1
0
A
ISO SOCKET
WHITE
WHITE
RED
RCA LINE OUT
REAR RIGHT SPEAKER JACK
REAR LEFT SPEAKER JACK
FRONT LEFT SPEAKER JACK
FRONT RIGHT SPEAKER JACK
RCA LINE OUT
RCA LINE OUT
RCA LINE OUT
RED
WIRES CONNECTION
ANTENNA JACK
Содержание mcd068
Страница 1: ......
