6
5. Adjust the position of Rail Assembly within the Rail
Brackets so the weapon’s center of gravity will be placed
over the center swivel. This will help the weapon maintain
balance when placed in the Forks. Photo12
6. Tighten the Tilt Tension Knob and Rotation Tension Knobs
on the Arm so they are snug and provide resistance to
rotation. Make sure there is adequate friction at each joint
to prevent the weapon from rotating or moving into an
unsafe position.
7. Place weapon into the Forks. If further adjustments of
Forks or Rail Assembly are needed for proper shooting
form, remove weapon from rest before making
adjustments. Once all adjustments have been made, verify
all lock knobs are securely tightened.
Rail Lock Knob
Tilt Friction Knob
Rail Extension Locks
Photo 12
NOTE: Remove Swing-Arm Assembly when entering or exiting chair for ease of use.
Do not adjust height with weapon resting in forks
3. Loosen both Fork Lock Knobs and flip the Front and Rear Forks upright. The height of each Fork can be
adjusted up or down to fit the geometry of your weapon. Once positioned to the desired height, tighten the
Fork Lock Knobs to hold Forks in the desired vertical position.
4. Adjust distance between the Forks by disengaging the Rail Extension Locks and sliding the Rails in or out as
needed to fit your weapon. Engage the Locks when adjustment is complete.
USAGE INSTRUCTIONS
Please refer to the photo on Page 1 to identify the parts and knobs of the ChairPod
1. Unfold the Legs of the Chair by pushing firmly on the frame and pulling on the cross-bar between the legs
2. Loosen the Clamp Lock Knob and insert the Swing Arm Post and Rail Assembly. Position the height of
Shooting Rail Assembly such that the Rear Fork is a little below shoulder level and tighten the Clamp Knob
Check that the Swing-Arm Post is firmly clamped before use. Do not adjust the post too
high so that it is only partially secured by the clamp.
