Caldera Vacanza Series, Инструкции перед доставкой

Страница: 11 / 16

230 v
olt
I
nstallatIon
Your spa contains a control box designed to operate at 230V, 60Hz. Installation of a 30 or 50 amp dedicated circuit
is required. The control box must be hard wired directly to a subpanel protected by a Ground Fault Circuit Interrupter
(GFCI). The subpanel containing the GFCI breaker is included with the
PALATINO
,
MARINO
and
VANTO
spas.
IMPORTANT NOTE : All electrical connections to the control box must be accomplished by a qualified electrician in
accordance with the National Electrical Code and in accordance with any local electrical codes in effect at the time
and place of installation.
All electrical connections must be made in accordance with the wiring information contained in this manual and on
the back of the control box panel. A licensed electrician should install a four-wire electrical service (two line voltages,
one neutral, one ground) from the main electrical service panel to the subpanel.
The grounding conductor must be at least #8 AWG. Your electrician should mount the subpanel in the vicinity of the
spa but it should not be closer than five (5) feet from the spa water edge (NEC 680-38 to 41-A-3).
INSTALLATION NOTE
: After the spa has been installed, your electrician can connect the conduit from the subpanel
to the spa’s control box and then complete the wiring connections in the control box.
NOTE : Complete step-by-step Installation and Wiring Instructions for all models are included in the Owner’s Manual
and with each subpanel, which can be obtained from your dealer.
WARNING : Removing or bypassing the GFCI breakers in the subpanel at any time will result in an unsafe spa and
will void the warranty.
POWER CONNECTION ACCESS FOR PALATINO,
MARINO, VANTO & TARINO
230V WIRING ACCESS
OPENINGS ON LEFT & RIGHT
HAND SIDE
EQUIPMENT
COMPARTMENT DOOR
PUMP DOOR
CONTROL BOX
Page 11
CAUTIONS
USE COPPER CONDUCTORS ONLY
USE SUPPLY WIRES SUITABLE FOR
75°C/167°F.
DISCONNECT ALL SUPPLY CONNECTIONS
BEFORE SERVICING.
CONNECT ONLY TO A CIRCUIT
PROTECTED BY A CLASS A GROUND-
FAULT INTERRUPTER.
THESE SPAS ARE INTENDED FOR USE WITH
GFCI SUBPANEL
ALL CANADIAN SPA MODELS USE #8 AWG
GREEN, GROUND.
INCORRECT WIRING WILL DAMAGE CIRCUIT
BOARDS.
REFER TO THE WIRING INSTRUCTIONS
INCLUDED WITH THE SUB-PANEL FOR
DETAILED WIRING INSTRUCTIONS.