MONARCH
®
WATER CARE SYSTEM
The Monarch system is comprised of the following products:
•
Monarch silver ion purifier
introduces silver ions into the spa water, inhibiting bacteria growth. When combined with MPS or chlorine, oxidizes particulates in
the spa water.
•
Monarch CD Ozone Generator -
The Monarch high output ozone system is the only ozone purification system approved for installation in your Caldera
®
Spa.
The Monarch ozone system utilizes Corona Discharge (CD) technology to produce a higher concentration of ozone than is produced by competing chip style
CD or ultraviolet light ozone systems.
•
Monopersulfate (MPS), Caldera Monarch Chlorine - Free Oxidizer
is an oxidizing chemical used to prevent the buildup of contaminants, maximize sanitizer
efficiency, minimize combined chlorine, and improve water clarity.
•
Sodium Dichlor (chlorine)
is the only recommended sanitizer that will work in conjunction with all of the other products in this system..It is important to follow
the recommended application and maintenance programs outlined for each product’s use.
If the spa is being used over an extended period or time, such as a whole afternoon or evening, additional sanitizer will be needed.
A weekly “shock treatment” is required
.
The shock treatment quickly destroys any remaining contaminants while revitalizing the silver ion purifier, allowing the silver ions to continue to be released into the
water. Without this weekly shock treatment, the silver ion purifier may stop releasing silver ions into the water.
To weekly “shock treat” your spa you may use either MPS or sodium dichlor. It will require much less sodium dichlor to administer the shock treatment than MPS (1
teaspoon of sodium dichlor has oxidizing capabilities comparable to 2 tablespoons of MPS). Sodium dichlor may be a more appropriate weekly shock for those users
that experience heavy bather load conditions.
IMPORTANT NOTE
: MPS is an oxidizer, not a sanitizer.
MONARCH SILVER ION PURIFIER INSTALLATION INSTRUCTIONS
When replacing the silver ion purifier (every four months), it is highly recommended that the spa be drained and refilled at the same time. After refilling the spa with water,
balance the Total Alkalinity (TA), Calcium Hardness (CH) and pH to the recommended levels. Shock the spa by adding sodium dichlor.
1. Release the cover locks and fold back the cover.
2. Remove the filter compartment cover.
3. Make sure the filter compartment is clear of any floating objects.
4. Drain the spa using the recommended procedures found in the Owner’s Manual.
PLEASE NOTE
: The Monarch
®
silver cartridge cannot be used with bromine, sodium bromide or biguanides. If you have previously used any of these products in the
spa, it is recommended that the shell and filter compartment be cleaned. It is also recommended that the filters be cleaned with a filter cleaner before the Monarch
cartridge is installed. (Review the shell and filter cleaning procedures.)
5. Push down slightly and turn filter basket counterclockwise to unlock, then pull out the basket and weir.
6. Grab handle and lift filter straight up and out.
IMPORTANT NOTICE
: If you have used the spa prior to this installation, clean the filter to ensure optimal performance from the Monarch silver ion purifier. It is
recommended to clean the filter each time you replace the Monarch cartridge.
WATER QUALITY AND MAINTENANCE
15
THE WATKINS WATER MAINTENANCE QUICK REFERENCE GUIDE
Ideal Range (ppm)
What Chemicals to Use
Steps
Minimum Maximum
To Raise
To Lower
1 Total Alkalinity
125
150
Sodium Hydrogen
Sodium Bisulfate
Carbonate, or
Sodium Bicarbonate
2 Calcium Hardness 150
200
Calcium Hardness
Use a mixture of
Increaser
75% hard water
and 25% soft water
or use a Stain and
Scale Inhibitor
3 pH
7.4
7.6
Sodium Hydrogen
Sodium Bisulfate
Carbonate
4 Sanitizer
See section on Maintaining the Sanitizer Level
Содержание Highland Series
Страница 1: ...Olympia Cumberland AventineTM Highland Series Owner s Manual ...
Страница 29: ...NOTES 26 ...
Страница 30: ...NOTES 27 ...
Страница 31: ...NOTES 28 ...