5.2.2
CASE #2 VANGUARD CONFIGURED TO USE A DMZ FOR VPN PASS-THROUGH
Figure 59 Vanguard configured with a DMZ for VPN Pass-Through
Vanguard – VPN Pass-Through Configuration Example Using a DMZ
In this scenario, the Vanguard is configured to use a DMZ to facilitate pass-through for the VPN connection. Apply these
parameter changes into the Vanguard.
LAN
» LAN Settings » LAN Masquerade = Disabled
Router
» Port Forwarding » DMZ = Enabled » Friendly IP Address = 0.0.0.0 » Destination IP Address = CISCO Router
(VPN server) LAN 1 IP Address.
Note:
It is also possible to use port forwarding (using configuration settings in the lower sections of this same tab)
instead of DMZ to configure the Vanguard for VPN Pass-through.
Vanguard 3000 Series Multicarrier Cellular Data Modem & IP Router PN 001-7300-100 Rev. B
| Page 96