7
Version: 1.1
©2019 CalAmp All rights reserved. 1301 W. George Bush Hwy, Suite 300, Richardson, TX 75080, 214-612-7000
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Consult the dealer or an experienced radio/TB technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Le pré
sent appareil est conforme aux CNF d’Insdustrie Canada applicables aux app
areils
radio exemp
ts de licence. L’exploitation est autoris
ée aux deux conditions suivantes: (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susce
ptible d’en
compromettre le fonctionnement.
Class B digital device notice
“CAN ICES
-3 (B)/NMB-
3(B)”
RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set fourth for mobile
transmitting devices operation in an uncontrolled environment. End users must follow the
specific operating instructions to satisfy RF exposure compliance.
The equipment should only be used where there is normally at least 20cm separation
between the antenna and all person/user.
This transmitter must not be co-located or operation in conjunction with any other
antenna or transmitter.
Any changes or modification not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
