4
Version: 1.1
©2019 CalAmp All rights reserved. 1301 W. George Bush Hwy, Suite 300, Richardson, TX 75080, 214-612-7000
3. Charging
Typically, the devices will arrive with a healthy charge in them but best practice is to
make sure the devices are charged fully before deploying them.
If the SC120
5
V battery becomes completely depleted, it could take up to an two hours
connected to power before the device begins reporting again. To prevent this, device
reporting rates should be configured when the SC120
5
V is not connected to power.
In the event that the SC120
5
V loses all battery voltage, the device will need to be
attached to power for at least 2 hour before reporting will resume.
4. Operation
The SC120
5
V was designed for simple operation.
There is only one button for the SC120
5
V. Once the button is pressed it will do a full
report with GPS and the flashing of LEDs gets progressively faster. If the device flashes
red three times, GPS signal was not acquired. GPS will be difficult to acquire indoors.
With the device ‘on’
, it is ready to be used for its normal operation. The button will turn
the device off and the unit will not send any reports.
The SC120
5
V has configurable reporting rates while the device is moving or stationary a
Device reporting rates can be modified in the SC iOn™ Command portal or through the
SC iOn™ Command JSON API.
