Cal Spas F-168, Руководство пользователя, Страница: 69 / 74

67
Low water pressure Jet valves may be partially or fully closed. Open the jet valves.
Filter cartridge may be dirty. Clean or replace the filter.
Pump may have airlock. Remove airlock by priming spa (page 14)
The suction fittings may be blocked. Remove any debris that may be blocking them.
The filter skimmer may be blocked. Remove the blockage.
Gate valves may be closed. Open gate valves. Note: Never operate your spa with the
gate valves closed!
Spa may be running in filtration mode. Press JETS or JETS 1 button to turn on high
speed pump.
No water pressure (no water Power may be switched off. Turn the power back on.
stream from any jets)
The pump may be defective. After you have tried all other troubleshooting, contact your
dealer for assistance.
Jets surge on and off Water level may be too low. Add water to normal level.
Pump problems
Pump runs constantly – will not
shut off
There may be a problem with circuit board. Contact your dealer.
Noisy pump The water level may be too low. Fill the spa with water level at 4 to 6 inches from the
top.
Filter cartridge may be dirty. Clean or replace the filter.
Pump may have airlock. Remove airlock by priming spa (page 14)
The suction fittings may be blocked. Remove any debris that may be blocking the suction
fittings.
Gate valves may be closed. Open gate valves. Note: Never operate your spa with the gate
valves closed!
Air may be leaking into the suction line. Contact your dealer for assistance.
Debris may be inside the pump. Contact your dealer for assistance.
Noise may be a sign of damage. Contact your dealer for service.
Symptom Possible Solutions
Pump turns off during operation Automatic timer may have completed its cycle. Press JETS or JETS 1 button to start the
cycle again.
Pump may have overheated due to the vents on the equipment door being blocked.
Make sure the front of the spa is not blocked to allow air flow.
The pump motor may be defective. Contact your dealer for assistance.
Pump has a burning smell while A burning smell may be a sign of damage. Contact your dealer for service.
running
Pump does not run Pump may have over heated. Let it cool for an hour and try operating the spa for a
shorter time.
Power to the spa may be shut off. Turn on or reset the GFCI circuit breaker. If this
does not solve the problem, contact your dealer or a qualified spa technician.