Cal Spas Cal Heat CU-100, Руководство пользователя

Страница: 52 / 76

Sauna Owner’s Manual
Operating Your Sauna
The control function for the 2.1kW heater and the 8.0 kW heater are identical. Please follow the
instructions below. The numbers in the figure above indicate that the user can change the location of
the controls:
1. Remove knobs.
2. Remove screws on the side of the heater.
Operating Zone For 9-Hour Delay Timer
The area from “OFF” to “ON” is the operating zone. This is the only time the heater is on.
Delay Zone
The area from “9” to “ON” is the delay zone. This means the heater can be programmed to come on
up to nine hours later.
HeaterPhase VAC Amps Wire Size
2.1kW 1 120 17.5 12-2 W/G
8.0kW 1 240 33.3 8-2 W/G
IR-100 and IR-200 Infrared Models Control Touch Pad
The IR-100 and IR-200 Infrared Saunas are controlled by a touch pad. The following instructions will
allow you to operate the sauna.
Setting the Temperature
1. Be sure the digital display is on (the LED will either be lit, or unlit). The digital display will indicate
the current temperature in the room.
2. Press the ‘Time/Temp Set’ button. The last stored temperature setting will flash on the digital
display.
3. While the digital display is flashing, press the ‘Time/Temp Set’ button to decrease the temperature
one degree.
Each time the button is depressed, the temperature will decrease 5 degrees.
4. To increase the temperature, wait 4 seconds until the display stops flashing; repeat Step 2 and
Step 3.
Page 48
LTR20071007, Rev. A