Cal Flame Chef C100, Руководство пользователя

Страница: 17 / 32

IAdjustments and Efficiency
INSTALLATION OF YOUR NEW GRILL
(continued)
Prior to shipment each burner is tested and
adjusted at the factory. Due to variations in
the location, conditions, gas supply or when
converting from one gas to another,
readjustment of the burners may be
necessary.
The flames of the burners (except the
rotisserie burners) should be visually
checked and compared to that of the figure
on the right.
Flames should be blue and stable with no
yellow tips, excessive noise or lifting. If any
of these conditions exist, check if dirt,
debris, spider webs, etc. block the air
shutter or burner ports. Proceed with air
shutter adjustment.
“Insert Cad drawing
showing proper grill
burner flame height”
Air Shutter Adjustment
A sheet metal disk known as an air shutter governs
the amount of air entering the burner. It is locked in
place by a setscrew, which must be loosened with a
screwdriver prior to lighting the burner.
1. To access the grill burner air shutters, set all the
knobs in the off position and remove them. Now take
out the valve panel by first removing four screws.
Pull the valve panel outwards while unplugging the
cables attached to the rotary igniter.
2. With a screwdriver, loosen the lockscrew on the
face of the air shutter.
3. Light the burner. For the following instructions be
careful as the burner may be very hot.
“Insert Cad
drawing
showing air
shutter
adjustment”