Cairox SOLANO CEILING-N-100, Техническая документация инструкция

Страница: 16 / 16

16
• The system with the heating medium must be prote cted against an increase of the heating medium
pressure above the permissible value (1.6 MPa).
• While screwing exchanger to pipeline - connecting stubs has to be hold by wrench.
• The device is designed for opera tion inside buildings, at temperatures above 0
o
C. In low temperatures
(below 0
o
C) there is a danger of freezing of the medium.
The manufacturer bears no responsibility for damage of the heat exchanger resulting from freezing
of the medium in the exchanger. It is forbidden to place any objects on the heater or to hang any
objects on the connecting stubs.
• The device must be inspected periodically. In the case of incorrect operation of the device it should be
switched off immediately.
• It is forbidde n to use a damaged device. The manufacturer bears no responsibility for damage resulting
from the use of a damaged device.
• If it is necessary to clean the exchanger, be careful not to damage the aluminium lamellas.
• For the time of performing inspect ion or cleaning the device, the electrical power supply should be
disconnected.
• In case water is drained from the device for a longer period of time, the exchanger tubes should be emptied
with compressed air.
Periodically need to be checked exchanger condition. Exchanger filled with dirt causes in heat output and air
flow drop.
If cleaning of heat exchanger is needed use listed guidelines.
• Disconnect power supply of unit.
• Dismount inlet grill guard
• It is recommen ded to use pressured air to clean the exchanger, air stream need to be directed
perpendicular to exchanger and moved along lamellas.
• It is prohibited to use water or sharp items to clean exchanger.
• Other installed equipment do not need be cleaned.
Outlet lamellas/blades are adjustable /-
10 ° range. By manually setting the angle of the airflow
stream, you can adjust an air barrier to the conditions around the door opening.