Cairox SOLANO CEILING-E-100, Техническая документация инструкция

Страница: 18 / 24

18
5.3.8. CONTROL SYSTEM – SETTING BMS ADDRESS
5.3.9. BMS REGISTERS
When connecting S-ECM modules to the T-box controller or BMS, you have to binary set addresses on each (each
S-ECM must have individual address) S-ECM module by DIP-switch SW1. To address modules check if the power
supply is turned off, than set then the addresses as shown in the table, than turn on the power supply .
switch down
Addresses S-ECM
switch up
Holding Register Data (read & write)
Inputs Register Data (write)
1
2
3
...
31
1 2 3 4 5 6
1 2 4 8 16 Y1
no.
register
address
name of parameter min max description
1 0x05 CurtainFanSpeedRef 0 3
Set value for curtain`s fan
0 FAN_SPEED0 Fan is off
1 FAN_SPEED1 1st step of fan is on
2 FAN_SPEED2 2nd step of fan is on
3 FAN_SPEED3 3rd step of fan is on
2 0x06 CurtainHeatRef 0 1
Set value for thermostat
0 HEAT_OFF Curtain`s thermostat is off
1 HEAT_ON Curtain`s thermostat is on
5 0x09 ContactDoor 0 1
Set value for thermostat
0 HEAT_OFF Curtain`s thermostat is off
1 HEAT_ON Curtain`s thermostat is on
no.
register
address
name of parameter min max description
1 0x06 CurtainFanSpeed 0 3
Current fan step
0 FAN_SPEED0 Fan is off
1 FAN_SPEED1 1st step of fan is on
2 FAN_SPEED2 2nd step of fan is on
3 FAN_SPEED3 3rd step of fan is on
2 0x07 CurtainValveState 0 2
Current Valve status
1 VALVE_CLOSE Valve closing
2 VALVE_OPEN Valve opening
5 0x09 ContactDoor 0 1
Set value for door contact
0 DOOR_CLOSE Door is closed
1 DOOR_OPEN Door is open