TIR-M50 can be remotely controlled and adjusted through interface system cable.
Video cable serves for external displaying and recording of the observed scene.
Pull the cap of the panel connector (located on the right side of the device). The cables
enable the connection with an external device like a PC, laptop or monitor with analog
video input.
One side of both cables ends with a 7-pin Fischer connector. When connecting it with
the device through the panel connector make sure the red markings (both on cable
Fischer connector and panel connector device) match.
20
21
BATTERY CHARGING
BATTERY CHARGING
Charger for RCR123 A batteries
When charging batteries, three yellow LED indicators in each slot will display the cur-
rent battery charging status. While the indicators blink, charging is in progress. When
charging completes, the three yellow LED indicators will illuminate steadily without
blinking.
When placing the batteries, observe the polarity and make sure that you insert batter-
ies in the charger properly (with the + (plus) and – (minus) in the correct position. In-
serting the batteries incorrectly causing all three yellow LED indicators to blink. Should
this occurs reposition the batteries to the correct polarity.
ATTENTION!
Insert not more than one battery In a single slot! Do NOT use the 12 V car cable for
the Intellicharger to charge the optional Battery Pack !
ATTENTION!
Recharge only the batteries provided in the delivery set!
Observe the polarity when placing the batteries in the charger!
2
1
CABLE CONNECTION
CABLE CONNECTION
Video cable
System cable (USB)
