12
31-2000694 Rev. 1
9 INSTALL MOUNTING SCREWS
WARNING
Mounting screws must be used.
Failure to do so could result in the oven falling out of
the cabinet, causing serious injury.
NOTE:
Before drilling the pilot holes, make sure the
oven is pushed as far back into the opening as it will
go and is centered.
A.
Tip the top of the oven toward you so the bottom of
the unit can slide into the cutout first.
B.
Slide the oven the remaining way into the opening
so that the side flanges and control panel are against
the cabinet frame. Make sure that the oven is
centered in the opening.
C.
Open the door, place a rack in the oven and make
sure that the rack in the unit is level.
D.
Drill pilot holes through the side flanges into the
cabinet.
E.
Place the included washers around the mounting
screws and drive the screws into the side flanges. It
is recommended that the screws
be hand tightened.
Installation Instructions
8 SLIDE OVEN INTO OPENING
A.
Loop
(do not tie)
a 36” (91 cm) string around the
conduit before the oven is slid into place. This will
keep the conduit from falling behind the oven.
B.
Lift oven into the opening. Use removable
wireformed handles on sides to lift unit. Do not lift
unit by handle or conduit. Two people are required
to lift this oven. Carefully push against oven front
frame. Do not push against outside edges.
C.
Leave oven a few inches forward of the cabinet
front frame. Do not push the unit all of the way into
the cutout.
D.
As you slide the oven back, pull the string so that
the conduit will lie on top of the oven in a natural
loop.
E.
When you are sure the conduit is out of the way,
slide the oven ¾ way back into the opening.
Remove the string by pulling on one end of the
loop.
Pull Out
on String
Loop While
Pushing
the Oven Into
the Cabinet
