Cafe CCP06BP Series, Руководство пользователя и инструкции по установке

Страница: 11 / 61

10
49-1000491 Rev. 3
TOOLS NEEDED
• Phillips Screwdriver
• Measuring Tape
• Carpenter’s Level
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
—
Observe all governing codes
and ordinances. Save these instructions for local
inspector’s use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – .HHSWKHVHLQVWUXFWLRQVIRU
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Beverage center Installation
can vary
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
LOCATION REQUIREMENTS
IMPORTANT: Before use, this beverage center must
be installed properly.
NOTE: Allow the beverage center to sit upright on its
base for at least one hour before installation.
• Do not install the beverage center where the
temperature will go below 55°F (13°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the beverage center where the
temperature will go above 110°F (43°C) because it
will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the beverage center in a location
exposed to water (rain, etc.) or direct sunlight.
Installation
Instructions
Beverage Center
Questions? Visit our Website at: cafeappliances.com
In Canada, visit cafeappliances.ca
IMPORTANT: Handle with care when moving beverage
center to avoid either damaging the refrigerant tubing or
increasing the risk of a leak.
IMPORTANT: If the beverage center has been placed in
DKRUL]RQWDOSRVLWLRQIRUDQ\SHULRGRIWLPHZDLWRQHKRXU
before plugging in to allow the refrigerant to settle.
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
INST
ALLA
TION INSTRUCTIONS
PARTS SUPPLIED
Anti-tip Brackets (Qty 4)
7RH.LFN%UDFNHWV4W\
Protective Guard (Qty 1)
7RH.LFN4W\
Handle (Qty 1)
´$OOHQ:UHQFK4W\
Screws
Screw A
- Qty 4
Screw B
- Qty 6
Screw C
- Qty 4
Screw D
- Qty 4
Screw E
- Qty 2