Capital Automotive Equipment
Model:4PG8000
Raise the lift off the safety locks by pushing the UP button on the power unit.
make sure
you raise the lift by
at least two inches to allow adequate clearance for the locks to clear.
Press the LOCK LEASE HANDLE and the lock latches will leave the lock blocks in post continuously.
Push the LOWERING HANDLE on the power unit until the lift has descended completely.
When lowering the lift PAY CAREFUL ATTENTION that all personnel and objects are kept clear.
ALWAYS keep a visual line of site on the lift AT ALL TIMES. ALWAYS make sure that all FOUR
LOCKS are disengaged. If one of the locks inadvertently locks on descent the lift and/or vehicle
may disrupt causing personal injury or death.
Weekly Maintenance
Lubricate all rollers with general purpose oil or WD-40.
I Check all cable connections, bolts and pins to insure proper mounting.
I Lubricate safety lock pivot points with general purpose oil or WD-40.
Monthly Maintenance
I Check safety locks to insure they are in good operating condition.
I Check all cables for excessive signs of wear
I Make a visual inspection of ALL MOVING PARTS and check for excessive signs of wear
I Replace ALL FAULTY PARTS before lift is put back into operation.
WARNING!
NEVER EXCEED THE RATED CAPACITY
of lift.
DO NOT USE LIFT
if any component is found to be defective or worn.
NEVER OPERATE LIFT
with any person or equipment below.
ALWAYS STAND CLEAR
of lift when lowering or raising.
ALWAYS INSURE SAFETY LOCKS ARE ENGAGED
before entering work area.
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all four safety locks are engaged.
