![background image](http://html.mh-extra.com/html/cadillac/2013-xts/2013-xts_owners-manual_481691311.webp)
Black plate (17,1)
Cadillac XTS Owner Manual - 2013 - 1st - 4/13/12
Vehicle Care
10-17
5. Wipe the dipstick with a
clean rag.
6. Replace the cap and completely
tighten it.
7. Remove the cap again and look
at the fluid level on the dipstick.
When the engine is hot, the level
should be at the hot MAX level.
When the engine is cold, the
fluid level should be between
MIN and MAX on the dipstick.
What to Use
To determine what kind of fluid to
use, see
Recommended Fluids and
Lubricants on page 11
‑
13
. Always
use the proper fluid.
Washer Fluid
What to Use
When adding windshield washer
fluid to the vehicle, be sure to read
the manufacturer instructions before
use. If you will be operating your
vehicle in an area where the
temperature may fall below freezing,
use a fluid that has sufficient
protection against freezing.
Adding Washer Fluid
The appropriate message will
appear on the Driver Information
Center (DIC) when the fluid level is
low. See
Washer Fluid Messages on
page 5
‑
44
.
Open the cap with the washer
symbol on it. Add washer fluid until
the tank is full. See
Engine
Compartment Overview on
page 10
‑
5
for reservoir location.
Notice
.
When using concentrated
washer fluid, follow the
manufacturer instructions for
adding water.
.
Do not mix water with
ready-to-use washer fluid.
Water can cause the solution
to freeze and damage the
washer fluid tank and other
parts of the washer system.
.
Fill the washer fluid tank only
three-quarters full when it is
very cold. This allows for
fluid expansion if freezing
occurs, which could damage
the tank if it is
completely full.