3. Find the jacking location from the diagram
above and use the corresponding cutouts
located in the plastic molding.
The front location is (A) 8.5 inches (21 cm)
from the rear edge of the front wheel well, and
the rear location (B) is 3.5 inches (8.5 cm)
from the front edge of the rear wheel well.
The notches may also be labeled JACK with
an arrow pointing to the jacking location on
the vehicle.
{
CAUTION:
Getting under a vehicle when it is jacked
up is dangerous. If the vehicle slips off
the jack you could be badly injured or
killed. Never get under a vehicle when it
is supported only by a jack.
{
CAUTION:
Raising your vehicle with the jack
improperly positioned can damage the
vehicle and even make the vehicle fall.
To help avoid personal injury and vehicle
damage, be sure to fit the jack lift head
into the proper location before raising
the vehicle.
424
Содержание 2007 DTS
