Cadillac 2007 DTS, Руководство пользователя

Страница: 379 / 508

Brakes
Brake Fluid
Your brake master
cylinder reservoir is
filled with DOT-3 brake
fluid. See
Engine
Compartment Overview
on page 356
for
reservoir location
and access.
There are only two reasons why the brake fluid
level in the reservoir might go down. The first
is that the brake fluid goes down to an acceptable
level during normal brake lining wear. When
new linings are put in, the fluid level goes back
up. The other reason is that fluid is leaking out of
the brake system. If it is, you should have your
brake system fixed, since a leak means that
sooner or later your brakes will not work well,
or will not work at all.
So, it is not a good idea to top off your brake fluid.
Adding brake fluid will not correct a leak. If you
add fluid when your linings are worn, then you
will have too much fluid when you get new brake
linings. You should add or remove brake fluid,
as necessary, only when work is done on
the brake hydraulic system.
{
CAUTION:
If your vehicle has too much brake fluid,
it can spill on the engine. The fluid will burn
if the engine is hot enough. You or others
could be burned, and your vehicle could be
damaged. Add brake fluid only when work
is done on the brake hydraulic system.
If the ignition is on and the brake fluid is low, the
SERVICE BRAKE SYSTEM message will be
displayed in the Driver Information Center (DIC).
See
DIC Warnings and Messages on page 239 .
379