6
[
U
]-[0] ADJUST KEYPAD TONE
1) Press [
U
]-[0]
The LCD screen will prompt you to use the scroll keys located on
the right of the display to raise or lower the tone.
2) Use the up scroll key to raise the tone.
Use the down scroll key to lower the tone.
The keypad will emit a continuous tone to allow you to hear the
current selection.
3) When the desired tone is reached, press the [#] key to set this tone and exit the mode.
[
U
]-[
x
] VIEW ZONE STATUS
1) Enter [
U
]-[
x
]
The LCD Screen will display the zone status.
2) Use the up and down scroll keys
to browse through the descriptions.
The LCD Screen will display the list of ALL zones in sequential
order by zone number
3) Press [#] to exit this function.
[
U
]-[3] VIEW ALARM MEMORY
1) Enter [
U
]-[3]
The LCD Screen will display the zone description for the zones.
2) Use the up and down scroll keys
to browse through the alarm memory.
The LCD Screen will display the list in sequential order by zone
number.
3) Press [#] to exit this function.
[
U
]-[5] CHANGING USER CODES
Note: For partitioned systems, someone changing the code of another person must have access to all or more
partitions than the user being changed.
1) Enter [
U
]-[5]
The LCD Screen will prompt for a code.
2) Enter [master code]
The LCD Screen will prompt for a user Number.
3) Enter the 2 digit user number (always 2
digits, i.e. "03" for user 3)
The LCD screen will prompt for a new code.
4) Enter the new user code designated for that individual. The sounder will beep 3 times if it rejects the code.
5) If another user code needs to be programmed, return to step 3.
6) To exit Code Programming, press [#] while the LCD screen is prompting for a new user number.
[
U
]-[6] ASSIGNING AUTHORITY LEVEL
Note: You must have authority to the partition you wish to add or remove from another person’s authority.
1) Enter [
U
]-[6]
The LCD Screen will prompt for a code.
2) Enter [master code]
The LCD Screen will prompt for a user Number.
3) Enter the 2 digit user number (always 2
digits, i.e. "03" for user 3)
The LCD screen will prompt for a new code. The LCD will now
prompt you for the first in the following list of attributes.
PROMPTS
If Prompt #1 ("Outputs used?") is
answered NO, the LCD will display the
four messages below.
If Prompt #1 ("Outputs used?") is
answered YES, the LCD will display the
four messages below.
(#1) Outputs used?
Open / Close Rprt?
Bypass enable?
Arm / Disarm?
Master code?
Output 4 enable?
Sched arm only?
Output 3 enable?
Arm only?
Output 2 enable?
Reserved
Output 1 enable?
