4.
ASSEMBLY INSTRUCTIONS
Assembly and Use
Light Back
Leaks
Model 186F and 187F
Models 184F and 185F
Use Outdoors Only.
indoubt. Also check that there is no foreign material inside the venturi. Re-light the appliance as described in Section 5 below. Should the
flame persistently light back return the product to your authorised
Ensure the appliance is used away from flammable materials. Minimum safe distances are; above the appliance 1.2m, at the rear and sides 600mm
(See Fig.1).
Ensure that the assembled product is stable and does not rock.
Never leave the appliance unattended when lit.
This appliance consumes oxygen and needs ventilation for optimum performance and for the safety of those in close proximity.
Do not modify the appliance. Do not use it for anything for which it has not been designed.
During use, parts of the appliance will become hot (particularly the burner). Avoid touching hot parts with bare hands, the use of gloves is
recommended.
Keep young children away from the appliance at all times.
Do not twist or pinch the hose.
Do not move the appliance while in use.
In the event of light back (where the flame burns back and ignites at the jet) immediately turn OFF the gas supply by firstly closing the control valve
on the gas cylinder and then the appliance valve. After the flame is extinguished remove the regulator and check the condition of its seal, replace the
seal if
CADAC repairagent.
If there is a leak on your appliance (smell of gas), turn OFF the gas supply, firstly at the gas cylinder and then on your appliance by turning the respective
knobs fully clockwise. Take both the cylinder and the appliance outside immediately into a well ventilated flame-free location where the leak may be
detected and stopped.
If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame. The correct way is to smear the joints with soapy
water, if bubbles form then there is a gas leak. Immediately turn OFF the gas supply, firstly by closing the control valve on the gas cylinder
and then the appliance valve. Check that all the connections are properly fitted. Re-check with soapy water.
If a gas leak persists return the product to your CADAC dealer for inspection / repair.
The hose length should be no less than 800mm and should not exceed 1.5m, check the expiry date on the hose and replace when necessary.
Do not twist or pinch the hose. Ensure that it is routed away from the stove body so as to prevent deterioration / damage to the hose caused by heat.
Fit the one end of the low-pressure hose onto the regulator nozzle and the other end onto the stove nozzle, by pushing it on firmly until fully seated against
the back shoulder on the nozzle (See Fig. 2).
Ensure that the connections are secure and do not allow gas to leak.
Ensure that the appliance valves are in the OFF position by turning the knobs fully clockwise to the stop (See Fig. 3).
Fit the wire grid to the stove body by aligning the legs on the wire grid with the corresponding holes in the stove body. The wire grid simply rests on the
stove body.
Fit the pot stands to the stove body by aligning the tags underneath the pot stand with the corresponding slots on the stove body. Take note that the pot stand
only fits in one way. Make sure that the notch on the pot stand ring is aligned with the dimple on the stove body.
Fit the grill plate to the body by first aligning the outer two (2) lugs with the corresponding pot stands.
Lower the grill plate onto the pot stand ensuring that all the location lugs align with the pot stands.
Make sure that the grill plate is properly fitted before using it.
The pot stands and grill plates can be used in any configuration, (i.e. two pot stands, two grills or one pot stand and one grill).
NOTE:
The hose and regulator are not supplied. For details contact your local stockist.
GB
Fig. 5
Bottom view of aluminium grill plates
located to pot stands
