CAD EOS 1, Руководство по обслуживанию

Страница: 14 / 14

14 14
Printhead Holder
1
2
4
5
3
6 7 4 5 3 8
Fig. 10 Removing / mounting printhead holder
Removing
X
Remove the casing.
X
Remove the printhead.
X
Remove the spring (2) from the spring bolt (1).
X
Lift the printhead holder (7), unlock the latch (4) and push the printhead holder with the spring (2) to the operator’s
side out of the chassis (3).
X
Remove the printhead holder (7) with the spring (2) completely from the retainer (6). In doing so remove the
printhead cable (8) from the printhead holder.
X
Keep the spring (2).
Mounting
X
Push the printhead holder (7) onto the retainer (6). In doing so insert the printhead cable (8) into the printhead
holder.
X
Push latch (4) and spring hook (5) of the printhead holder through the gap of the chassis (3).
i
Notice!
For the following mounting of the spring (2) it is recommended to push the printhead holder in a position,
where the latch (4) is clamped by the chassis but not completely locked yet.
X
Mount the spring (2) onto the spring hook (5).
X
Push the printhead holder (7) further until the latch (4) clicks into place.
X
Mount the spring (2) onto spring bolt (1).
X
Mount the printhead.
X
Mount the casing.
Replacing Assembly Units