CAD EOS 1, Руководство по обслуживанию

Страница: 10 / 14

10 10
Danger!
Risk of death via electric shock!
X
Before opening the rear cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
Tear-off Plate / Cutter / Printhead / Print Roller
Replacement and mounting of these units are described in the
w
Operator’s Manual EOS.
Casing
1
2
3
5
1
3
4
Fig. 3 Removing the cover Fig. 4 Removing / mounting the casing
Removing the cover
X
Lift the cover (1) by turning by 60°.
X
Push the cover out of the hinges (2) of the cover plate (3) diagonally to the ground.
i
Notice!
For service work it is recommended to remove the casing consisting of cover (1) and cover plate (3)
connectedly. It is not necessary to separate the cover from the cover plate.
Removing the casing
X
Open the cover (1).
X
Loosen 2 screws (5).
X
Push the cover plate (3) with the cover (1) to the connector side.
X
Lift the cover plate (3) with the cover (1) from the printer.
Mounting the casing
X
Insert the hooks (4) into the slot of the bottom and push the casing to the control panel side.
X
Fix the cover plate with 2 screws (5).
Replacing Assembly Units