18
27/11/2013
15:50
To enable LoPower:
1. Switch on the V6 in TX mode, press
Menu
. Turn the selection dial to <LoPower>,
press
OK
. Dial to <ON> and press
OK
.
2. Once the LoPower is enabled, the LoPower will be shown as <Lo> at one stop below
1/128 power in relative power mode, or one stop below the lowest power of each
group in absolute power mode.
3. To disable LoPower output, follow step 1 to enter the LoPower menu. Choose <OFF>
and press
OK
.
13 Camera Shutter Release
Notes:
This function requires the use of a separately purchased shutter release cable for connection
between the transceiver and camera. This cable is NOT included.
13.1 Basic Setup
(Fig. 20)
A minimum of two Cactus V6 transceivers are required to operate Cactus V6 as a wireless
shutter release.
1. Set V6 transceivers into correct modes: Transmitter to <TX>, Receiver to <RX>. This
will automatically power on the transceivers.
2. Connect RX to your camera using an appropriate shutter release cable.
3. Set both TX and RX to the same channel using the Channel Dial. When setting
channels, ensure the channel set on the wireless shutter release transceiver pair is
different from that of wireless flash trigger.
4. Half press the
Test Button
on TX to test auto focus. The status LED on both TX and RX