14
27/11/2013
15:50
for users to command the power of flashes in the most convenient way.
12.1 Relative Power
Similar to ordinary flash display, V6 TX indicates the power level of the remote flashes in
proportion to full power under Relative Power mode, i.e. 1/1 for full power, 1/2 for half power,
etc. It demonstratives the fraction of power in relation to the full power of the particular flash
concerned. Upon switching on V6 in TX mode, the LCD will show the relative power levels of
all active groups.
When V6 is in Relative Power mode, select a particular power ratio on V6 will automatically
command the flash to be set to that power ratio. For instance, if you assign 4 different flashes
to Group A, B, C and D respectively, choosing flash ratio value of 1/16 on V6 under Relative
Power mode will automatically set the power ratio of the flashes to 1/16.
Note that the small single digit indicates the increment between major power levels.
(Fig. 14)
1.
Single Group Power Adjustment
There are two ways to adjust power level at a particular group.
1. Two steps: To adjust the power level of a particular group, long press the group
button until the power level of the chosen group is highlighted on LCD. Turn the
selection dial left (to decrease) or right (to increase) to the desired power level.
2.
Short
cut:
There
is
also
a
short
cut
to
single
group
power
adjustment:
press
the
group
button
and
turn
the
selection
dial
simultaneously.
Once
the
adjustment
is
finished,
un
‐
press
the
group
button.
(Fig.
15)
