Cabletron Systems SSIM-R2-02, Инструкция по установке и эксплуатации

Страница: 22 / 48

15
Console Configuration SSIM-R2-02/SSIM-R8-02 HSTR SmartStack Interface Modules Installation and User Guide
•
The console automatically returns to the greeting screen after five minutes of
inactivity. Five minutes is the default value. The time can be changed at the
Console Configuration
menu. The
Console Configuration
menu is within the
Configuration
menu, under the main menu.
•
For protection against inadvertent or unauthorized access to configuration
screens, you can set a password that users must enter at the Greeting screen. If
no password is configured, just press
Enter
and the main menu is presented.
Navigating within the Menus
Use the arrow keys (also referred to as cursor keys) to move the highlight over a
selection. If the selection is a menu, pressing the
Enter
key displays a new screen of
information; if the selection is a command, such as
Reset
, pressing the
Enter
key
initiates that function.
A heading with three “dots” after it means that when that heading is selected, a
submenu or screen is displayed. Unless specified differently, all the screens or
menus are accessed in the same way.
Configuration Overview
Execute the following general steps to configure a SSIM-Rx-02:
•
Determine which VLANs the HSTR ports should connect.
•
Determine which VLAN, if any, should be untagged.
•
Configure the 802.1Q VLAN ID for all the BRFs that should be tagged.
•
Make sure that each 802.1Q VLAN ID matches that of the HSTR equipment
on the other end.
•
Assign CRFs to the HSTR port, thereby creating one virtual port in each
VLAN. You can create new CRFs to make sure that the CRFs do not have
conflicting ring numbers, as discussed in “Ring Number Restriction” on
page 14.
•
Configure the HSTR port, in particular the operation mode.
•
Configure the virtual ports, in particular the tagging mode. The relevant
configuration menus are described in the port configuration sections.