Cabletron Systems SmartSwitch Router, Справочное руководство

Страница: 190 / 226

Chapter 29: SYS Error Messages
29 - 6 SSR-8 Error Reference Manual
-SYS-E-NOSUCHIMAGE no image named <image_name>
Explanation:
This message appears when the user tries to delete a non-existent image with the
'system image delete' command.
Recommended Action:
The user should run the 'system image list' command to see the available images and
then choose a name from those displayed. It is important to note the difference between
the name of the image (displayed in the left column of 'system image list') and the
version number of the image (displayed in parentheses in the right column). The image
*name* should be used with the 'system image delete' command.
-SYS-E-BAUDFAIL <name>: Failed to change baud rate
Explanation:
This message appears when the 'system set terminal baud' command was run to change
the baud rate of the serial management console port, but the system was unable to set
the baud rate to the value requested.
Recommended Action:
This message probably indicates a programming error, because the CLI parser checks
the baud rate for validity before trying to change the serial port. In general it indicates
that the serial hardware cannot run at the requested baud rate.
-SYS-E-FLASHMNTFAIL <number> MB Flash card could not be mounted
Explanation:
This message appears at boot time when the flash card cannot be mounted.
Recommended Action:
This message may indicate that this type of card is not supported, or that the write-
protect switch is turned on, or that the file system contained in the flash card is corrupt.
Reboot the SSR using the same flash card. If problem persists, obtain a new flash card
or call Cabletron Systems technical support.