Cabletron Systems SmartStack STS16-20FRM, Инструкция по установке и эксплуатации

Страница: 127 / 260

113
Switch Configuration SmartStack STS16-20RM/STS16-20FRM Token Ring Switches, P/N: 9032957-01
Clear Table
Deletes all CrossLinks.
Setting up a CrossLink
To add a CrossLink between two STS16-20RM series switches, determine which
ports to use for the CrossLink. Use at least two ports.
Observe the following precautions and use the following steps to set up a
CrossLink:
•
Disable or disconnect the ports before creating or changing a CrossLink.
•
You must define the CrossLink for both connected STS16-20RM series
switches before physically connecting their linked ports. Do not connect the
cables before configuring the switches; if you do, you may create loops.
•
Cable only the ports you have added to the CrossLink menu. If you connect
additional ports between two STS16-20RM series switches, a loop results.
1. Disconnect the ports you want to add to the CrossLink, or disable them using
the Port Configuration menu.
2. For each STS16-20RM series switch, select the CrossLink Configuration
menu, then choose Add Entry from the menu bar at the bottom of the screen.
3. Enter the ports for the first CrossLink, separated by spaces.
4. Choose Return. (A reset is not required).
5. Repeat steps 1 through 4 for the other STS16-20RM series switches.
6. Set the Address Aging Time to the same value for all of the STS16-20RM
series devices.
7. If you disconnected the ports in the CrossLink, reconnect them. If you disabled
them using the Port Configuration menu, use the menu to re-enable them.