Cabletron Systems SmartStack STS16-20FRM, Инструкция по установке и эксплуатации

Страница: 74 / 260

60
SmartStack STS16-20RM/STS16-20FRM Token Ring Switches, P/N: 9032957-01 Installation
2. Using the switch Cabling Chart provided by your network administrator as a
guide, connect the cables between the switch and other devices as illustrated in
Figure 21. Note that the figure illustrates an RJ-45 connector on each end.
Depending on the cable type you use, the device end of the cable may also have
a 9-pin D-shell or 150 ohm Data Connector.
3. If the switch is rack-mounted, dress the switch end of the cables through a cable
management bracket, if one is present on your rack.
4. Label each end of the cables so that it will be easy to find the device if you have
to troubleshoot a network problem.
Suggested information to place on the label includes the room location of the
device at the other end, a unique cable identification number, the MAC address
of the connected device, and the number of the port to which the cable is
attached.
5. To continue installing the switch, go to “Applying Power” on page 62.
Figure 21. Connecting Devices to Token Ring Ports
Connecting Devices to the Token Ring Ports
Using Building Wiring
If you will use building wiring (in-the-wall cables) to connect the device to the
switch, perform the following steps:
1. If you have an SSIM, connect it using the instructions in the documentation
shipped with it and then return here.