Cabletron Systems MMAC-Plus 9T125-24, Руководство пользователя

Страница: 15 / 30

2-3
Installation
Setting the Module Card DIP Switch
An eight position DIP switch is located on the module card as shown in Figure 2-1
and in Figure 2-1. The functions of this switch are listed in Table 2-1.
See the Cautions at the end of this table.
Table 2-1. Function of DIP Switch
Switch Function Description
8 Clear
Password
1
When toggled, this switch clears user-entered
passwords stored in NVRAM, and restores the
default passwords. Once reset you can use the
defaults or enter new passwords.
7 Clear
NVRAM
2
The module uses NVRAM to store user
entered parameters such as IP addresses,
device name, etc. To reset these parameters to
the factory defaults, toggle this switch. Once
reset, you can use the defaults or enter new
parameters which are stored in NVRAM when
the module is powered down, and remain
there until the switch is toggled again.
6 Force BootP
Download Toggling this switch after pulling the board out
of the
SmartSwitch 9000
, clears download
information from NVRAM and forces image
files to be downloaded from the station
configured to act as that modules’ BOOTP
server.
5 Reserved For Factory Use Only
4 Reserved For Factory Use Only
3 Reserved For Factory Use Only
2 Reserved For Factory Use Only
1 Reserved For Factory Use Only
1
Do not toggle Switch 8 unless you intend to reset the user configured passwords
to their factory default settings.
2
Do not toggle Switch 7 unless you intend to reset the user parameters to the
factory default settings.
!
CAUTION