CONNECTING TO THE NETWORK
Page 4-3
4.1.2
Connecting to Network Ports, SEHI-32 and SEHI-34
The SEHI-32 has a 50-pin Champ connector, while the SEHI-34 has
two 50-pin Champ connectors. This configuration of the SEHI allows
you to run a 50-pin feeder cable from the SEHI to a punch down block.
Each Champ connector supports 12 10BASE-T, twisted pair segments.
Note: Refer to Appendix A for information about wiring the SEHI to a
punch down block.
To connect the SEHI into an existing twisted pair wiring system:
1.
Connect a 50-pin feeder cable to the Champ connector on the SEHI
as shown in Figure 4-2.
Figure 4-2. SEHI-32/34 Network Ports
2.
Attach the feeder cable to the punch down block, or patch panel.
In most cases, you can connect the feeder cable directly to a
Champ connector located on the punch down block. If not, you
must wire the feeder cable to the punch down block using the
punch down information in Appendix A.
3.
At the device end of a segment, attach the segment to a 10BASE-T
compliant Ethernet device.
EPIM-1
EPIM-2
EPIM-T
LNK
EPIM-T
LNK
24X
13X
12X
1X