Chapter 3: Installation/Removal
7F06-02 FDDI SmartSwitch Interface Module User’s Guide
3-7
3.3.4
Removing the 7F06-02 from the 7C04 or 7C04-R
Workgroup SmartSwitch
The 7F06-02 Module, inserted in the 7C04 or the 7C04-R
Workgroup SmartSwitch, can be removed whenever necessary. Follow
the steps below and refer to Figures 3-6 or 3-7 to remove the module.
Note:
Before removing the 7F06-02 module, attach the antistatic wrist
strap included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. As a precaution, power down the MMAC 8 before beginning the
installation or removal of any modules. At the very minimum the 7C04
or 7C04-R must be pulled to disconnect it from the power source.
Damage to modules may result if this procedure is not followed.
2. Use a slotted screwdriver to loosen the two screws that secure the
module to the chassis.
3. Locate the two ejector tabs on the module (below the screws on the left
and right end of the module).
4. Simultaneously press left on the left ejector tab and right on the right
ejector tab until the module ejects from the backplane.
5. Grasp both ejector tabs and carefully slide the module out of the
chassis.
Figure 3-6
Removing the 7F06-02 Module from the 7C04 Workgroup
SmartSwitch
1
2
3
4
Screws
Ejector Tabs
Содержание FDDI
