Cabletron Systems Fast Network 10, Руководство пользователя

Страница: 26 / 132

Chapter 1: Introduction
Page 1-16 Fast Network 10 User Guide
The following sections describe LCM command syntax and the basic
LCM commands for logging in, logging out, and getting help.
• LCM commands used for configuring the FN10 are described in
Chapter 3, Configuring Your FN10.
• LCM commands used for monitoring and managing the FN10 are
described in Chapter 4, Monitoring and Managing Your FN10.
• LCM commands used for adding and deleting Port filters are described
in Chapter 5, FN10 Filters.
1.6.1 Command Syntax Conventions
The following conventions apply as you use LCM commands:
• Press the Enter key to execute a command after you type it in.
• A port range is either a single port number, or a list of port numbers
separated by commas or hyphens. For example,
3
is port
3
;
3,7
are
ports
3
and
7; 3-5
are ports
3
,
4
, and
5
; and
3-5,7
are ports
3,4,5,
and 7.
• To quit any command, press the Control-C keys (^C or Ctrl-C).
• You can abbreviate any command where there is no ambiguity; if there
is ambiguity, LCM responds with an error message.
• Commands are not case sensitive.
• Any invalid commands or misspellings will receive an error message.
• A previous command can be repeated by typing
!!
.
• MAC addresses are displayed in little-endian Ethernet bit order, with
each octet separated by a colon. For example:
FN10 >address 00:40:27:04:1a:0f
NOTE
The FN10 Local Console Manager (LCM) Commands
Reference Card lists the available LCM commands, including
each command’s options.