Cabletron Systems Cabletron CyberSWITCH CSX5500, Руководство пользователя

Страница: 588 / 729

USER’S GUIDE
588 CyberSWITCH
dnet
Required parameter. The destination network number.
dnode
Required parameter. The destination node Id.
timeout
Optional parameter. The number of seconds to wait for a reply message. The valid range is
from 1 to 60 seconds. The default value is 10 seconds.
nnnn
Optional parameter. The data size to be included in the ping packet. The valid range for the
data size is 5 to 586 octets. The default value is 100 octets.
An example atalk ping command could read as follows:
atalk ping 1.3 30 /d200
which would send a ping to node number 3 or network number 1, with a timeout value of 30
seconds, and the data size would be 200 octets.
atalk port
This command will display AppleTalk port information. A sample output screen is shown
below:
The fields in this display are defined as follows:
type
The port type. Possible types are LAN, WAN, WAN UnNumbered.
Note that the WAN UnNumbered port information is not taken from the previously configured
AppleTalk Routing
port information , but is derived from the AppleTalk Routing static route
configuration information.
state
The state of the port as it is in the process of coming up. Possible states include:
listen - The port is listening to see if any other routers are out on the network.
probing - The port is probing the network to see if its suggested AppleTalk address is
unique, or if it is already in use.
Port 1
type: LAN
state: UP
address: 20.20 network range 20-21
flags: extended phase-2 soft-seed
default zone: zone1
lan port: 1 physical address: 00409A001AB3
Port 2
type: WAN
state: UP
address: 30.30 network range 30-31
flags: extended phase-2 soft-seed
default zone: zone1
Port 3
type: WAN UNNUMBERED state: UP
address: 20.20 (borrowed)
remote device: MAC4